Simmons Cuddler Power Recliner

Simmons Cuddler Power Recliner

Simmons Cuddler Power Recliner

Troubleshooting your power touch recliner you begin ensuring that have, power to the outlet have power disconnect your power. Cord from outlet and check connection points unplug, and plug back connection points specifically plug ensure you disconnect. Reconnect your touch wire and touch junction make, sure that there are wires caught moving parts plug. Power cord back into outlet place your chair, upright position and test power for touch models only. Leave unit plugged into power source place chair side, unplug the din plug this will reset touch buttons. Wait seconds plug the din plug back place, chair the upright position.

Test power replacing your touch. Junction sure to disconnect power source before replacing components, place your chair side snip ties that hold touch. Junction place and disconnect from touch wire remove the, plug from motor this has disconnected your touch. Junction from the chair will replace touch junction with, obtained through customer service plug plug in attach excess. Cord back rail using like the excess using additional, zip ties will hold junction place on back rail you. Will then connect your touch wire and touch, junction place your chair upright position plug back into. Your power source and test your chair.

Power, have successfully replaced your touch junction replacing your transformer disconnect. Power source from the wall flip your chair, side disconnect cord from motor replace with transformer obtained through. Customer service plug into the same cord attached, motor plug back into your power source place. Your chair upright position test your chair power have, successfully replaced your transformer replacing your power motor disconnect your. Power source place your chair on its side, unplug power cord unplug your plug from side. Of the motor remove clevis andrew and remove power, motor reinstall the power motor using clevis andrew. To attach mounting.

Bracket be sure tangle wires within the, motor mounting brackets again use your clevis andrew. Attach the motor mounting bracket plug your plug reconnect, your power cord plug into your power source place. Your chair upright position test power have successfully replaced, your power motor

Leave a Comment